Salli - WARRANTY
Salli Systems / Easydoing Oy (“Salli”) gives a warranty for new products as follows: 10 years for the saddle chairs (except Salli Light and Salli Slim models, and Salli Outlet SwingFit and Salli Outlet Swing 5 years); 5 years for Salli Paddler; 2 years for tables, accessories (e.g. Allround, Stretching Support, Elbow Rest, ErgoRest, Elbow Table, Foot Support, Foto Control, Ergoelbo etc.), Salli Riding Pad and Salli Beanbag; and 1 year for Salli Driver.
Salli Systems / Easydoing Oy (“Salli”) gives a warranty for used products as follows: 5 years for the saddle chairs (except Salli Light and Salli Slim models 1 year, and Salli Outlet SwingFit and Salli Outlet Swing 2 years); and 1 year for tables, accessories (e.g. Allround, Stretching Support, Elbow Rest, ErgoRest, Elbow Table, Foot Support, Foto Control, Ergoelbo etc.), Salli Riding Pad and Salli Beanbag.
The warranty from the date of purchase of the Salli product (“Product”), for any structural defect in the Product or a fault in its materials or assembly, which arise during regular and normal indoor use of the Product (“Defect”).
Any claim for a Defect under this warranty must be made in writing to Salli immediately and in no case later than within seven (7) days from the date the distributor/end user became or should have become aware of the Defect. Any claims not made within the said time period will be null and void. The date of the purchase must be verified by the serial number of the Product and the receipt of the end user or bookkeeping of the distributor or Salli. The warranty time (2–10 years) is determined by the date of purchase.
The warranty given by Salli does not cover damage or faults caused by:
- any leather damaging liquids
- chair falling on the ﬂoor or dropping (see photos below)
- abrasion against hard, rough or sharp objects that leaves marks
- piercing or impressions made by sharp objects
- normal wear and tear
- any amendment or alteration made to the Product whatsoever by or at the request of the distributor or end user
- any parts or objects other than those approved by Salli in writing prior to assembly used in the Product or in any way attached to the Product
|Pictures of upholstery material breakage of fallen chairs. The upholstery material may not be tearing immediately after the blow, but later when the chair is being used. However, the fall or impact has caused the damage and therefore the warranty does not cover it.|
The distributor/end-user shall send, at their cost, the defective Product to Salli’s factory in Rautalampi, Finland or to Salli’s warehouse or other places mutually agreed upon between the parties. Upon the arrival of the defective Product, Salli shall inspect the Product without any delay.
The distributor/end-user may also make a written description of the defective part and take a photo about it and send this material directly to Salli by mail or e-mail. Salli may also pay for the transportation of the defective part/product once it has verified that the defect is covered by the warranty. The repaired or replaced Product will be returned to the distributor or the end user by Salli.
Should the Product not be defective or the Defect not be covered by this warranty, the distributor/end-user shall reimburse to Salli reasonable costs for the inspection of the Product and possible shipments.
Should it be unreasonably expensive or impractical to send the defective Product to the Salli factory or to clear the warranty coverage by written or picture materials, the Defect must be verified by an impartial expert who is agreed on by Salli and the distributor/end-user for his warranty to be valid.
When the warranty coverage is clear according to the fore said measures, Salli may also send the replacement parts to the distributor/end user. The warranty of Salli does not cover the work or costs of assembly of the spare parts, or disassembly of the old parts, on behalf of the end-user or distributor but will provide them with adequate written or oral instructions.
The leather quality in the upholstery of the Product may change according to the quality level. In A1 quality only a few of the leather’s natural structure marks are clearly visible because the leather has been made smooth and even during the manufacturing process. As a result, the leather is tough, durable and easy to clean. A2 quality is a combination between naturality and comfort and durability. The natural surface marks are partly visible and the leather is still resistant to wear and tear.
Salli’s limited warranty is in lieu of all other warranties whether written, oral, express or implied. The distributor’s/end user’s sole claim is for repair or replacement, at Salli’s sole discretion, of any defective Product covered by the warranty.
Salli shall not be responsible for any indirect, consequential, incidental or punitive damages or lost profits or loss of goodwill. Salli does not make and hereby disclaims any other warranty, statutory or otherwise, express or implied with respect to the Product including, without limitation, any warranty of fitness for a particular purpose or merchantability. However, this Product Warranty does not and is not intended to limit the rights that consumers may have under mandatory law. Distributor shall be responsible for, and Salli shall have no obligation to honour, any warranties that the Distributor or any of its sub-distributors or any other third party, as the case may be, provides to its customers and/or end-users with respect to the Product that is in addition to, or inconsistent with, the warranties provided by Salli in this Agreement.